The piece of plexi-glass is at the front here. Click the picture for a slightly larger, but much clearer version.
The finished back.
The finished front.
Finished from above.Project completed successfully!
Sunday, August 3, 2008
power supply (now 0.75-30V / 2.7A), part 5.
One last part is needed to put the wires together. Just incase it needed to be taken apart (maybe because things can screw up sometimes? ;-P ) I wanted to be able to de-solder the wires leading to the heat sink from the print board. Therefore I cut out a piece of plexi-glass (I cut a semicircle), drilled some holes in it and mounted solder lugs on them. One for each wire to be connected. After this it was testing time (basically a check to see if nothing explodes ;-).
The piece of plexi-glass is at the front here. Click the picture for a slightly larger, but much clearer version.
The finished back.
The finished front.
Finished from above.
Project completed successfully!
The piece of plexi-glass is at the front here. Click the picture for a slightly larger, but much clearer version.The finished back.The finished front.Finished from above.Project completed successfully!
Subscribe to:
Post Comments (Atom)
3 comments:
It needs a Kenwood knob on the front.
Vincent, you're too much of a wiry intellectual for me... and you do these things just for fun...?//?!?
@ Kees: No it doesn't ;-P
@ Gled: Yeah, I do this for fun. Other people sit in front of the tellie all evening :-)
Post a Comment