The IKEA BESTA

Today I put two Bestas together. It is the simplest piece of IKEA furniture I have seen so far. I wanted two, one to put my TV on and one to put my printer on.

It comes in one box only. Easy peasy.

There is of course the standard IKEA Allen key included but I had no use for it. I did need these guys though; a flat screw driver and a Phillips screw driver.

Start by screwing these guys in the top piece. You need six.

Then place the sides and fix them.

The short ones are used for the sides, the long ones are for the thicker middle part.

Sides and middle part attached.

Slide in the back pieces.

Then screw the remaining six fixation points in to the bottom part (recognisable by the extra, smaller holes)

Turn the cupboard on its side.

To mount the bottom piece, place it next to the cupboard and fix one side first.

Then fix the remaining points.

The Besta standard comes with these little feet.

I bought the higher legs for it though.

They are easy to attach. (And you will get 4 Allen keys of the same size...)

And there it is.

The cupboard in place.

Test Track II (N scale)

Before starting a project as big like the coffee table model railroad, I want to make sure certain things will work. Therefore I am now making a little test lay-out that allows me to test all the things that could potentially block creating the coffee table track.

It's also my introduction to digital railroading so it is also good to try it out like this first in that respect.

Before anything can be tested, three phases have to be completed:

1. Construction of the lay-out
   
2. Wiring the lay-out
   
3. Writing software to operate the lay-out
   

This blog post describes phase one: Constructing the lay-out.

First the plans. It will be a two level lay-out. This is the bottom part:

A simple reverse loop which is entered after driving down the spiral through the inside track.

This is the top part:

When arriving at the top level the train can run through the loop and go down again or it can enter the station where the loco can be driven to the front of the train again if necessary.

I used the spiral parts that I created before. For tips on how to create one, look at this blog post.

NOTE: The reverse loops must be isolated from the rest of the track otherwise you will get an electric short cut!

I got a 100 x 54 cm piece of wood. Well, MDF. Mark the holes for the threaded rods for the spiral.

After the holes are drilled we can start.

Laying out track is not very hard. Here I'm up to the first level in the spiral. I put a little piece of double sided tape underneath the track in some places so the track lies nice and sturdy.

Here the spiral is finished.

I cut another piece of MDF. This one had a size of 54 x 50 cm. I attached it with threaded rods as well.

Then bridge the gap between the spiral and the top level and lay out the rest of the track.

Spiral view.

Top view. Ready for wiring.