Power supply (now 0.75-30V / 2.7A), part 4.

Mounting the transistors on the heat sink is a yucky job. You have to put paste in between the transistors and the heat sink to help conducting the heat. I used one with silver in it, it conducts heat better. Unfortunately , because of the silver it also conducts electricity better.

I first put a thin layer of paste on the heat sink. And thin means THIN. It's only purpose is to fill up microscopic holes to flatten the surface more for better contact.

Then I put the mica insulating washers in place. I actually made the holes for the transistor pins a lot bigger because I don't want the pins to come in contact with the paste due to the paste's electrical conductivity.

After this I put another very thin layer of paste on the bottom of the transistor and placed them on top of the mica washer.

After this the transistors have to be screwed on to the heat sink. The casing of the transistor will actually carry 34 Volts but I didn't want to put 34 volts on the whole heat sink, hence the mica washers. One of the screws was isolated from the transistor and is simple to use. The other one was in contact with the transistor because it will serve as the +34V contact of the transistor. It therefore is screwed directly on the transistor and the screw is shielded from the heat sink by little plastic cylinders inside the hole in the heat sink. Put a solder lug on it and fix it.

The end result of today's DIY.

PS: A note on the mica washers. The ones you buy can be pretty thick, some times more than 0.25 mm. This influences the thermal conductivity, you want them to be thinner. With a sharp knife and some patience you can "slice" them in thinner ones. The one I bought were 0.1 mm and I sliced them in half.